Home > News > Content
Pure Sine Wave Inverter Checks The Repair Steps
- Jul 24, 2018 -

When encountering the shutdown of Pure Sine Wave Inverter, the first step is to shut down the Pure Sine Wave Inverter through the power off operation above the liquid crystal panel, and then the Pure Sine Wave Inverter will be controlled to stop the rotation of the circuit breaker output through the exchange output of Pure Sine Wave Inverter. After disconnecting the back switch of Pure Sine Wave Inverter, the Pure Sine Wave Inverter will directly conduct the exchange cabinet. After it Pure going Wave makes the inside of the two rotating is directly input circuit breaker directly into the closed state, and then disconnect yourself in front of the opening, if the Pure directly going Wave makes the size of the set became an external power supply, also can cut off the inside of the external power supply, circuit breaker after go out to run.

After determining Pure going Wave makes and ac side completely disconnect, just will use their own test universal form in the side of the communication, just will make sure you don't take points, after sure won't be to connect it with electricity, and then can be directly received the above the bottom line, observe the Pure going Wave is makes the existence of the local, hanging deformation observation is exist, check out if there are any surroundings humidity above, all the air inlet is check the filter is normal or not.

Start the Pure going Wave makes, first turn on the ground to pull down, then put the box on the transformer close to the side after the opening, and then the Pure going Wave makes ac output of the xi 'an road open directly to the switch phase, after closing a junction box to start, and then use the closed dc cabinet can truly input began to work, then put two dc are to open phase, wait for about a minute of time, in the other things are all open, Pure Sine Wave Inverter is ready to go.


Copyright © Wenzhou Roger Electronic Technology Co.,Ltd All Rights Reserved.